Abdul, Aziz and Ming, Yang and Tetsuhide, Shimizu and Tsuyoshi, Furushima (2021) Effect of Martensitic Transformation and Grain Misorientation on Surface Roughening Behavior of Stainless Steel Thin Foils. Eng - MDPI, 2. pp. 372-385.

	Text (Peer Review) MPT dan GMO.docx Download (796kB)
	Text (Peer Review) MPT dan GMO.pdf Download (694kB)
	Text (Fulltext) eng-02-00024.pdf Download (7MB)
	Text (CHeck Plagiarism) trunitrin Effect of Martensitic Transformation and Grain Misorientation on Surface Roughening Behavior of Stainless Steel Thin Foils (1).pdf Download (4MB)

Abstract

Abstract: The surface roughening (Ra), martensitic phase transformation (MPT), and grain misori�entation (GMO) behavior of stainless steel 304 and 316 in various grain sizes (Dg) were studied experimentally, including five cycles of sequential uniaxial tensile stress testing and Scanning Elec�tron Microscope-Electron Back Scattered Diffraction (SEM-EBSD) investigation. The MPT and GMO characteristics were sequentially investigated using tensile testing and SEM-EBSD analysis. The correlation between MPT, GMO, martensitic volume fraction (Mf), and Ra behavior were investigated. The experimental results showed that increasing the total strain from 5.0% to 25.0% increased the MPT, GMO, and Mf, which were transformed from the metastable austenitic phase in stainless steel (SUS) 304. The increasing total strain increased Ra for all kinds of Dg. Furthermore, SUS 304 and SUS 316 were used to compare the roughening mechanism. The MPT was very high and spread uniformly in fine grain of SUS 304 thin foil, but the MPT was low and not uniform in coarse grain of SUS 304 thin foil. There was no MPT in SUS 316 thin foil, both in coarse and fine grain. The GMO in fine grains, both in SUS 304 and SUS 316 thin foils, spread uniformly. The GMO in coarse grains, both in SUS 304 and SUS 316 thin foils, did not spread uniformly. Surface roughness increased higher in coarse grain than fine grain for both of SUS 304 and SUS 316 thin foil. SUS 304 increased higher than SUS 316 thin foil. The effect of inhomogeneous deformation due to the MPT is a more important factor than GMO in coarse grain. Keywords: martensitic phase transformation (MPT); grain misorientation (GMO); surface roughening (Ra); grain size (Dg)

Actions (login required)

View Item